Minicom Advanced Systems Smart 4 Guía de usuario Pagina 64

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 92
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 63
Troubleshooting – Safe Mode
Restoring the Device Firmware
64 | SmartRack 116 IP
To
restore factory defaults
1. In the Safe Mode menu
(see
A warning appears.
2. Click .
An additional warning
appea
Figure
3. Click OK.
The factory defaults are
r
appears.
4. Click Reboot
to restart the unit
5.3
Restoring the Device Firmware
To receive the Upgrade firmware required to restore the device firmware, contact
Minicom Technical Support
support@minicom.com
the hard disk of a computer connected to the network.
T
o restore device firmware
1. In the Safe Mode menu
(see
A warning appears.
2.
Locate the Upgrade firmware
The firmware upgrades. When the process finishes
restore factory defaults
:
(see
Figure 69), click Restore Factory Settings
.
Figure 70 – Warning
appea
rs.
Figure
71 – Additional Warning
r
estored. When the process finishe
s, the following figure
Figure 72 – Reboot
to restart the unit
.
Restoring the Device Firmware
To receive the Upgrade firmware required to restore the device firmware, contact
support@minicom.com
.
Save the Upgrade firmware on
the hard disk of a computer connected to the network.
o restore device firmware
:
(see
Figure 69), click Firmware Upgrade.
Locate the Upgrade firmware
, click Install, then click Start Upgrade.
The firmware upgrades. When the process finishes
, the following figure
.
s, the following figure
To receive the Upgrade firmware required to restore the device firmware, contact
Save the Upgrade firmware on
, the following figure
appears.
Vista de pagina 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 91 92

Comentarios a estos manuales

Sin comentarios