Minicom Advanced Systems Remote Power Switch Manual de usuario descargar pdf (Pagina 10)

OPERATING GUIDE

PPPoE

Where you want to connect to the RPS via a modem, from the drop-down menu

choose to connect always to the Point-to-Point Protocol over Ethernet (PPPoE).

If you choose to connect always, type the PPPoE Login name and password.

12. SNMP

From the menu click SNMP. The SNMP settings appear, see Figure 8.

Here you configure the SNMP settings to be used by an NMS (Network

Management System). (Eg: SNMPC or HP Openview).

Figure 8 SNMP Settings

MIB System

System Name - type a name for the RPS.

System Contact - type the name of the administrator.

System Location – type the RPS location.

Access Control

Manager IP Address - Set the IP address from which the administrator can

manage the RPS. You can have up to 8 IP addresses. *.*.*.* is the default setting

without any access restriction for IP.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Sin comentarios

Minicom Advanced Systems Remote Power Switch Manual de usuario Pagina 10