
Troubleshooting – Safe Mode
Restoring Factory Defaults
64 | Smart 108/116 IP
5.2 Restoring Factory Defaults
You can restore all Smart 108/116 IP settings to their default values.
To restore factory defaults:
1. In the Safe Mode menu (see Figure 47), click Restor
e Factory Settings.
A warning appears.
Figure 48 – Warning
2. Click
.
An additional warning appears.
Figure 49 – Additional Warning
3. Click OK
.
The factory defaults are restored. When the process finishes, the following figure
appears.
Figure 50 – Reboot
4. Click Reboot to restart the unit.
5.3 Restoring the Device Firmware
To receive the Upgrade firmware required to restore the device firmware, contact
Minicom Technical Support
the hard disk of a computer connected to the network.
Comentarios a estos manuales