Minicom Advanced Systems Smart 4 Guía de instalación descargar pdf (Pagina 12)

SMART CAT5 SWITCH 16 IP

15. Connecting to Ethernet

The Ethernet connector on the Smart 16 IP can be used either for a 100 Mbps

100BASE-TX connection or for a 10 Mbps 10BASE-T connection. The adapter

adjusts to the appropriate operation mode automatically.

16.

17.

10 Mbps Connection

For 10BASE-T Ethernet networks, the Fast Ethernet adapter uses Category 3, 4, or 5

UTP/FTP cable. To establish a 10 Mbps connection, the cable must be connected to

a 10BASE-T hub. Ensure the cable is wired appropriately for a standard 10BASE-T

adapter. Align the RJ-45 plug with the notch on the adapter's connector and insert it

into the adapter's connector.

100 Mbps Connection

For 100BASE-TX Fast Ethernet networks, the Smart 16 IP supports Category 5

UTP cabling. To establish a 100 Mbps connection, the cable must be connected to a

100BASE-TX hub.

1. Make sure that the cable is wired appropriately for a standard 100BASE-TX

adapter.

2. Align the RJ-45 plug with the notch on the adapter's connector and insert it into

the adapter's connector.

Note! The UTP/FTP wire pairs and configuration for 100BASE-TX cable are

identical to those for 10BASE-T cable when used with Category 5 UTP/FTP cable.

18. Connecting the RS232 Serial cable

To operate the Smart 16 IP system with the Control software located on the

Marketing & Documentation CD, connect the RS232 Serial cable.

To connect the RS232 Serial cable:

1. Connect the cable’s RJ11 connector to the Smart 16 IP’s Service port. See

Appendix A for the Service Connector Pin-out.

2. Connect the cable’s DB9F connector to the computer’s Serial port.

The figure below illustrates the connections.

11.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Minicom Advanced Systems Smart 4 Guía de instalación Pagina 12