Minicom-advanced-systems IP Control Manual de usuario descargar pdf (Pagina 15)

USER GUIDE

17. Administration > Serial Settings

Where you have a Serial device connected to the system you must configure the

RS232 settings.

To do so:

From the menu click Serial Settings, the Serial Settings appear, see Figure 9.

Figure 9 Serial Settings

Type a device name and choose the correct device parameters. Note! Where you

have a Minicom Serial Remote Power Switch connected, see below Assign to

RPS.

17.1 Show

Tick Show to make the Serial device appear in the list of servers/devices that can

be accessed.

17.2 Assign to RPS

Where a Minicom Serial Remote Power Switch (RPS) is connected to the Serial

port, tick this box. All other parameters are then grayed out. See the RPS

Installation Guide for further information on installing and operating the RPS.

18. Security > Settings

Configure the security features, such as Account Blocking, Password Policy and

Idle Timeout, as explained below.

From the Security section click Settings, the Security Settings appear, see Figure

10.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 32 33

Sin comentarios

Minicom-advanced-systems IP Control Manual de usuario Pagina 15